Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
12-69
1
2
3
12
6
6
7
8
12.1 Error Code List
12.1.8 Error code list (6000 to 6999)
6010
[OPE. MODE DIFF.]
The operational status of the control system and
standby system in the redundant system is not the
same.
(This can be detected from the standby system of
the redundant system.)
■Collateral information
• Common Information:–
• Individual Information:–
■Diagnostic Timing
•Always
Synchronise the operation statuses of the control
system and standby system.
RUN:
On
ERR.:
On
CPU Status:
Continue
QnPRH
6020
[OPE. MODE DIFF.]
At power ON/reset, the RUN/STOP switch settings
of the control system and standby system are not
the same in a redundant system.
(This can be detected from the control system or
standby system of the redundant system.)
■Collateral information
• Common Information:–
• Individual Information:–
■Diagnostic Timing
• At power ON/At reset
Set the RUN/STOP switches of the control system
and standby system to the same setting.
RUN:
Off
ERR.:
Flicker
CPU Status:
Stop
6030
[UNIT LAY. DIFF.]
• In a redundant system, the module configuration
differs between the control system and standby
system.
• The network module mode setting differs
between the two systems.
(This can be detected from the control system or
standby system of the redundant system.)
■Collateral information
• Common Information:Module No.
• Individual Information:–
■Diagnostic Timing
• At power ON/At reset/At tracking cable
connection/At operation mode change
• Match the module configurations of the control
system and standby system.
• In the redundant setting of the network
parameter dialog box, match the mode setting of
System B to that of System A.
6035
[UNIT LAY. DIFF.]
In a redundant system, the CPU module model
name differs between the control system and
standby system.
(This can be detected from the standby system of
the redundant system.)
■Collateral information
• Common Information:–
• Individual Information:–
■Diagnostic Timing
• At power ON/At reset/At tracking cable
connection/At operation mode change
Match the model names of the control system and
standby system.
Error
Code
(SD0)
Error Contents and Cause Corrective Action
LED Status
CPU Status
Corresponding
CPU