Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
12-27
1
2
3
12
6
6
7
8
12.1 Error Code List
12.1.4 Error code list (2000 to 2999)
2200
[MISSING PARA.]
There is no parameter file in the drive specified as
valid parameter drive by the DIP switches.
■Collateral information
• Common Information:Drive Name
• Individual Information:–
■Diagnostic Timing
• At power ON/At reset/ STOP RUN
• Check and correct the valid parameter drive
settings made by the DIP switches.
• Set the parameter file to the drive specified as
valid parameter drive by the DIP switches.
RUN:
Off
ERR.:
Flicker
CPU Status:
Stop
Qn(H)
QnPH
QnPRH
[MISSING PARA.]
There is no parameter file at the program memory.
■Collateral information
• Common Information:Drive Name
• Individual Information:–
■Diagnostic Timing
• At power ON/At reset/ STOP RUN
Set the parameter file to the program memory. Q00J/Q00/Q01
[MISSING PARA.]
Parameter file does not exist in all drives where
parameters will be valid.
■Collateral information
• Common Information:Drive Name
• Individual Information:–
■Diagnostic Timing
• At power ON/At reset/ STOP RUN
Set a parameter file in a drive to be valid. QuU
2210
[BOOT ERROR]
The contents of the boot file are incorrect.
■Collateral information
• Common Information:Drive name
• Individual Information:–
■Diagnostic Timing
• At power ON/ At reset
Check the boot setting.
Q00J/Q00/Q01
*3
Qn(H)
QnPH
QnPRH
QnU
2211
[BOOT ERROR]
File formatting is failed at a boot.
■Collateral information
• Common Information:Drive name
• Individual Information:–
■Diagnostic Timing
• At power ON/ At reset
• Reboot.
• CPU module hardware fault. (Contact your local
Mitsubishi representative, explaining a detailed
description of the problem.)
Qn(H)
QnPRH
QnU
2220
[RESTORE ERROR]
• The device information (number of points)
backuped by the device data backup function is
different from the number of device points of the
PLC parameter.
After this error occurred, perform restore per
power-on/reset until the number of device points is
identical to the number of device points in the PLC
parameter, or until the backup data is deleted.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:–
■Diagnostic Timing
• At power ON/ At reset
• Set the number of device points at the time of
backup to the device point setting in [PLC
parameter]. Then, turn ON from OFF power
supply, or reset the CPU and cancel reset.
• Delete the backuped data, and turn ON from
OFF power supply, or reset the CPU and cancel
reset.
QnU
Error
Code
(SD0)
Error Contents and Cause Corrective Action
LED Status
CPU Status
Corresponding
CPU
*3 The function version is B or later.