Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
12-38
3013
[PARAMETER ERROR]
Multiple CPU auto refresh setting is any of the
followings in a multiple CPU system.
• When a bit device is specified as a refresh
device, a number other than a multiple of 16 is
specified for the refresh-starting device.
• The device specified is other than the one that
may be specified.
• The number of send points is an odd number.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Parameter number
■Diagnostic Timing
• At power-On/ At reset/ STOP RUN/
At writing to progurammable controller
Check the following in the multiple CPU auto
refresh setting and make correction.
• When specifying the bit device, specify a multiple
of 16 for the refresh starting device.
• Specify the device that may be specified for the
refresh device.
• Set the number of send points to an even
number.
RUN:
Off
ERR.:
Flicker
CPU Status:
Stop
Qn(H)
*1
QnPH
[PARAMETER ERROR]
In a multiple CPU system, the multiple CPU auto
refresh setting is any of the following.
• The total number of transmission points is
greater than the maximum number of refresh
points.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Parameter number
■Diagnostic Timing
• At power-On/ At reset/ STOP RUN/
At writing to progurammable controller
Check the following in the multiple CPU auto
refresh setting and make correction.
• The total number of transmission points is within
the maximum number of refresh points.
Q00/Q01
*1
[PARAMETER ERROR]
In a multiple CPU system, the multiple CPU auto
refresh setting is any of the following.
• The device specified is other than the one that
may be specified.
• The number of send points is an odd number.
• The total number of send points is greater than
the maximum number of refresh points.
• The setting of the refresh range crosses over the
boundary between the internal user device and
the extended data register (D) or extended link
register (W).
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Parameter number
■Diagnostic Timing
• At power-On/ At reset/ STOP RUN/
At writing to progurammable controller
Check the following in the multiple CPU auto
refresh setting and make correction.
• Specify the device that may be specified for the
refresh device.
• Set the number of send points to an even
number.
• Set the total number of send points within the
range of the maximum number of refresh points.
• Set the refresh range so that it does not cross
over the boundary between the internal user
device and the extended data register (D) or
extended link register (W).
QnU
*10
3014
[PARAMETER ERROR]
• In a multiple CPU system, the online module
change parameter (multiple CPU system
parameter) settings differ from those of the
reference CPU.
• In a multiple CPU system, the online module
change setting is enabled although the CPU
module mounted does not support online module
chang parameter.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Parameter number
■Diagnostic Timing
• At power-On/ At reset/ STOP RUN/
At writing to progurammable controller
• Match the online module change parameter with
that of the reference CPU.
• If the CPU module that does not support online
module change is mounted, replace it with the
CPU module that supports online module
change.
Qn(H)
QnPH
QnU
*8
Error
Code
(SD0)
Error Contents and Cause Corrective Action
LED Status
CPU Status
Corresponding
CPU
*1 The function version is B or later.
*8 The Universal model QCPU except the Q00UJCPU, Q00UCPU, Q01UCPU, and Q02UCPU.
*10 The Universal model QCPU except the Q00UJCPU.