Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
App-128
(4) Scan information
(5) I/O refresh
*1: This applies to the CPU of function version B or later.
TableApp.3.4 Special relay
Number Name Meaning Explanation
Set by
(When Set)
Corres-
ponding
ACPU
M9
Corresponding
CPU
SM415 2n (ms) clock
• This relay alternates between ON and OFF at
intervals of the time (unit: ms) specified in SD415.
• When Programmable Controller power supply is
turned ON or a CPU module reset is performed,
goes from OFF to start.
(Note that the ON-OFF status changes when the
designated time has elapsed during the execution of
the program.)
S (Status change) New
Qn(H)
QnPH
QnPRH
QnU
SM420 User timing clock No.0 • Relay repeats ON/OFF switching at fixed scan
intervals.
• When Programmable Controller power supply is
turned ON or a CPU module reset is performed,
goes from OFF to start.
(For the redundant CPU, however, this relay is
always OFF after system switching.)
• The ON/OFF intervals are set with the DUTY
instruction
n1: ON scan interval
n2: OFF scan interval
S (Every END
processing)
M9020
QCPU
SM421 User timing clock No.1 M9021
SM422 User timing clock No.2 M9022
SM423 User timing clock No.3 M9023
SM424 User timing clock No.4 M9024
SM430 User timing clock No.5
• For use with SM420 to SM424 low speed programs
S (Every END
processing)
New
Qn(H)
QnPH
SM431 User timing clock No.6
SM432 User timing clock No.7
SM433 User timing clock No.8
SM434 User timing clock No.9
TableApp.3.5 Special relay
Number Name Meaning Explanation
Set by
(When Set)
Corres-
ponding
ACPU
M9
Corresponding
CPU
SM510
Low speed program
execution flag
OFF : Completed or not
executed
ON : Execution under way.
• Goes ON when low speed execution type program is
executed.
S (Every END
processing)
New
Qn(H)
QnPH
SM551
Reads module service
interval
OFF : Ignored
ON : Read
• When this relay goes from OFF to ON, the module
service interval designated by SD550 is read to
SD551 to SD552.
UNew
Qn(H)
QnPH
QnPRH
TableApp.3.6 Special relay
Number Name Meaning Explanation
Set by
(When Set)
Corres-
ponding
ACPU
M9
Corresponding
CPU
SM580
Program to program I/
O refresh
OFF : Not refreshed
ON : Refreshed
• When this special relay is turned ON, I/O refresh is
performed after execution of the first program, and
the next program is then executed.
When a sequence program and an SFC program are
to be executed, the sequence program is executed,
I/O refresh is performed, and the SFC program is
then executed.
UNew
Q00J/Q00/Q01
*1
n(ms)
n(ms)
n1 scan
n2 scan n2 scan
DUTY n1 n2 SM420