Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD &RQILJXULQJ,QVWDOOLQJDQG2SHUDWLQJWKH7DSH6\VWHP
7DQGEHUJ'/73URGXFW0DQXDO
6WDWH ,QGLFDWRU'LVSOD\DQG$FWLYLW\
A tape cartridge is present, but
the handle is up (not
recommended)
The yellow Tape In Use indicator extinguishes. The
green Operate Handle indicator flashes. When the
Insert/Release Handle is lowered, the cartridge loads. If
handle will not lower, ensure the tape cartridge is
pushed all the way into the tape system.
The tape system detects an
error condition
Right- or left-hand indicators blink repeatedly. Try to
unload the tape and reinitialize the tape system by
pressing the Unload button, or turn system power off
then back on. The indicators stop blinking and the
system attempts reinitialization. Note that after pressing
the Unload button you may have to wait five minutes
before the Operate Handle indicator illuminates due to
the retry being attempted first. The indicators illuminate
steadily, then extinguish if the test succeeds.
The system is powered on with
the handle in open position
Operate Handle indicator is blinking. Close the
Insert/Release Handle and wait for indicator to
illuminate steadily.
7DEOH±3RVVLEOH7DSH6\VWHP6WDWHV)ROORZLQJ,QLWLDOL]DWLRQFRQWLQXHG
POST completes in about 15 seconds and the tape system should respond normally
to all commands (POST is complete after Stage 2 in Table 2-11). However, it
might take longer for the media to become ready.
After a bus reset, the tape system responds within a bus selection time-out period
(per the ANSI SCSI specification). A reset may have the Tape In Use indicator
blinking because a reset forces the tape to be rewound to BOT.