3D Innovations DLT8000 Gas Grill User Manual


  Open as PDF
of 391
 
7DQGEHUJ'DWD &RQILJXULQJ,QVWDOOLQJDQG2SHUDWLQJWKH7DSH6\VWHP
 7DQGEHUJ'/73URGXFW0DQXDO
 6HWWLQJ3DULW\&KHFNLQJ
Parity checking is the default setting for DLT8000 tape systems. If the system to
which you are configuring the tape system does not generate parity, disable parity
checking on the tape system by installing a jumper block on pin pair 1 / 2 on the
connector as shown in Figure 2-3. Note that this is the same connector as the one
used to select the setting for TERM PWR (Section 2.2.2).
)LJXUH±-XPSHU,QVWDOOHGRQ3LQ3DLU
'LVDEOHV3DULW\&KHFNLQJ
Jumper on Pin Pair 1 / 2
disables parity checking.
Front Bezel
Side View of Tape System
 previous next