Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
02'(6(/(&7&RPPDQGKKFRQWLQXHG
PS Parameters Savable. For MODE SELECT, this bit must be 0.
Additional Page
Length
This field indicates the number bytes in the page. However, the value does
not include bytes 0 and 1. The length is returned in MODE SENSE
commands and must subsequently be set to the same value when
performing MODE SELECT. If the page length does not match that expected
by the drive, a CHECK CONDITION status is returned, sense key set to
ILLEGAL REQUEST.
The drive returns a CHECK CONDITION status with sense key set to
ILLEGAL REQUEST if it receives an unsupported Page Code or a Page field
with values not supported or changeable. In such cases, no parameters are
changed as a result of the command.
CAP Change Active Partition. Not supported; must be 0.
CAF Change Active Format. Not supported; must be 0.
Active Format Not supported. Must be 0.
Active Partition Only partition 0 is supported. Setting this field to any other value causes
rejection by the drive with a CHECK CONDITION status, sense key ILLEGAL
REQUEST set.
Write Buffer Full
Ratio
The drive sets this field to 0. The drive uses an automatic adaptive
mechanism to adjust its Full Ratio according to the average data rates over
the SCSI bus.
Read Buffer Empty
Ratio
The drive sets this field to 0. The drive uses an automatic adaptive
mechanism to adjust its Empty Ratio according to the average data rates
over the SCSI bus.
Write Delay Time This field indicates the maximum time that the drive will wait with a partially
full buffer before forcing the data to tape (100 ms increments). The buffer
Full/Empty ratio, which is dynamic, can cause data to be written sooner than
the Write Delay Time would indicate. The Write Delay Time defaults to 200
(C8h). This causes the buffer to be flushed in 20 seconds. Maximum value is
6500 (1964h) and the minimum is 15 (0Fh). This represents a range from 11
minutes down to 1.5 seconds.
Values between 0 and 15 on a MODE SELECT, are rounded down to 0. This
causes the data to go straight to the medium without delay.
DBR Data Buffer Recovery. Not supported, must be 0.
BIS Block Identifiers Supported. This field is supported. Set to 1.
RSmk Report Setmark. Not supported, must be 0.
7DEOH±'HYLFH&RQILJXUDWLRQ3DJH²)LHOG'HVFULSWLRQV