Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
02'(6(/(&7&RPPDQGKKFRQWLQXHG
Block Length This field specifies the length, in bytes, of each logical block transferred over
the SCSI bus. A block length of 0 indicates that the length is variable
(specified in the I/O command). Any value other than 0 indicates the number
of bytes per block to use for READ, WRITE, and VERIFY commands that
specify a “fixed” bit of 1 (i.e., fixed block mode) which also causes the
transfer length in the command descriptor block to be defined as a block
count. If fixed bit is not equal to 1, this field is ignored.
7DEOH±0RGH3DUDPHWHU%ORFN'HVFULSWRU²)LHOG'HVFULSWLRQVFRQWLQXHG
0RGH3DJH'HVFULSWRUV
Following the MODE SELECT command’s Mode Parameter Block Descriptor are
the MODE SELECT pages, each of which sets a different device parameter. Each
mode page has a 2-byte header that identifies the page code and indicates the
number of bytes in that page.
Bit
Byte
76543210
0 PS (0) 0 Page Code
1 Additional Page Length
2 - Q
Page-Defined or Vendor Unique Parameter List
)LJXUH±02'(6(/(&73DJH'HVFULSWRU²'DWD)RUPDW
)LHOG1DPH 'HVFULSWLRQ
PS Parameters Savable. For the MODE SELECT (6) (10)
commands, this field is reserved (0).
Additional Page Length Indicates number of bytes in that page (not including bytes 0
and 1).
Page-Defined or Vendor
Unique Parameter List
Information in this field depends on the mode page. Refer to
Sections 5.9.2 through 5.9.9.
7DEOH±02'(6(/(&73DJH'HVFULSWRU²)LHOG'HVFULSWLRQV