Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
%HKDYLRU$W3RZHU2QDQG6&6,%XV5HVHW
The following apply to the DLT8000 tape drive’s behavior at power-on and/or
SCSI bus reset:
• When the Tandberg DLT8000 system is powered up, all device SCSI lines are
set to high impedence.
• The design of the DLT8000 tape drive does not allow it to generate any
spurious signals on the SCSI bus at power-on.
• Within five seconds of power-on, and within 250 milliseconds (typically under
4 milliseconds) after a SCSI bus reset, the DLT8000 tape drive responds to
SCSI bus selections and returns appropriate, normal responses. Tape motion
commands will be returned with Check Condition status, Sense Key Not
Ready, until the tape medium has been made ready.
• The tape drive implements the hard bus reset option.
• The tape medium is rewound to Beginning of Tape (BOT).
The DLT8000 tape drive recognizes multiple, successive SCSI bus resets and SCSI
bus resets of arbitrarily long duration. The tape drive recovers within the time
limits specified above following the last SCSI bus reset.
The tape drive goes through a calibration process at power up and loading of
medium.