Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
/2*6(16(&RPPDQG'KFRQWLQXHG
)LHOG1DPH 'HVFULSWLRQ
PPC Parameter Pointer Control. This bit musts be set to 0. A PPC of 0
indicates that the parameter data requested from the device starts
with the parameter code specified in the Parameter Pointer field
(Bytes 5 - 6) and return the number of bytes specified in the
Allocation Length field (Bytes 7 - 8) in ascending order of parameter
codes from the specified log page.
Note that the current implementation of the READ/WRITE
COMPRESSION page does not support a PPC other than 0. If
PPCbit is set, then the target terminates the command with CHECK
CONDITION status, sense key set to ILLEGAL REQUEST, and
additional sense code set to INVALID FIELD IN CDB.
SP Save Parameters. Not supported, must be set to 0. If for some
reason the Save Parameters bit is set, the command terminates with
a CHECK CONDITION status with a sense key of ILLEGAL
REQUEST and an ASC of INVALID FIELD IN CDB.
PC Page Control. This field defines the type of parameter values to be
returned:
3&7\SHRI3DUDPHWHU9DOXHV
00b Threshold Values
01b Cumulative Values
10b Default Threshold Values
11b Default Cumulative Values
• The Default Threshold Values are the maximum values that
each parameter can attain.
• The Current Cumulative Values are the values computed since
the last reset of the device (either via power-cycle, BUS
DEVICE RESET, or SCSI RESET.
• The Default Cumulative Values are the values to which each
parameter is initialized at a reset condition. Default values are
zero.
• By default, Current Threshold Values = Default Threshold
Values.
Note that all types of parameter values are changeable via LOG
SELECT.
7DEOH±/2*6(16(&RPPDQG'HVFULSWRU%ORFN²)LHOG'HVFULSWLRQV