Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
/2*6(/(&7&RPPDQG&KFRQWLQXHG
)LHOG1DPH 'HVFULSWLRQ
127(
Byte 2 of the Log Parameter Block is referred to as the Parameter Control Byte; it
is made up of six control bits plus one bit that is reserved.
DU Disable Update. This bit is not defined for LOG SELECT; the target
ignores any value in DU.
DS Disable Save. Not supported. DS and Target Save Disable (TSD)
must be set to 1. If DS and/or TSD are set to 0, command
terminates with CHECK CONDITION status, sense key set to
ILLEGAL REQUEST, and additional sense code set to INVALID
FIELD IN PARAMETER LIST.
TSD Target Save Disable. Not supported. TDS and DS must be set to 1.
If TSD and/or DS are set to 0, command terminates with CHECK
CONDITION status, sense key set to ILLEGAL REQUEST, and
additional sense code set to INVALID FIELD IN PARAMETER LIST.
ETC Enable Threshold Comparison. When set to 1, drive performs a
comparison with threshold values once the cumulative value is
updated. Comparison criteria is defined in Threshold Met Criteria
(TMC). If the comparison is met and the RLEC bit of MODE
SELECT / SENSE Control Page 0Ah is set to 1, then a UNIT
ATTENTION is generated for all initiators. The additional sense
code is set to THRESHOLD CONDITION MET. If the RLEC bit is 0
and the comparison is met, then UNIT ATTENTION is not
generated.
FRQWLQXHG
7DEOH±/RJ3DUDPHWHUV)LHOG'HVFULSWLRQVFRQWLQXHG