Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD $SSHQGL[&
& 7DQGEHUJ'/73URGXFW0DQXDO
127(
On UN*X systems, use the FTP utility to transfer the binary firmware
image. Be sure to specify “type image” before using the “get” or “put”
commands, otherwise extra characters may be added to the file, causing
it to be invalid. The image file should be exactly 1286 * 512 bytes in size.
When making the update tape, copy the image file to the tape media
using an appropriate block size as shown in Table D-1, that is, dd, ltf, and
so on. The tape must be uncompressed.
& )LUPZDUH8SGDWH3URFHGXUH
This section describes the procedure to update the firmware of the tape drive’s
PCBA. The update requires a cartridge that holds the update firmware image.
Firmware updates from a host are also supported (see the section on the SCSI
command WRITE BUFFER in Chapter 5).
&$87,21
If a powerfail occurs during the firmware update process (when the new
image is actually being programmed into the FLASH EEPROMs), the tape
drive’s PCBA will be rendered unusable. When performing a firmware
update, take all possible precautions to prevent power failure to the tape
drive.
Make sure you are using a DLTtape that bears the firmware image of the required
revision level copied to it.
1. Put the tape drive into the firmware update mode. To do this
A. Remove any cartridge in the target tape drive and close the handle (down
position).
B. Press the UNLOAD button on the drive front panel and hold the button
until the WRITE PROTECTED indicator begins blinking (approximately
six seconds). This indicates that the tape drive has recognized your request
for firmware update mode and is waiting for the sequence to complete.