Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
/2*6(/(&7&RPPDQG&KFRQWLQXHG
)LHOG1DPH 'HVFULSWLRQ
TMC Threshold Met Criteria. Once the criteria specified in this field is
met and the ETC bit is 1 and the RLEC bit in MODE SENSE /
SELECT Control Page is set to 1, then UNIT ATTENTION is
generated for all initiators.
The criteria for comparison are:
&RGH %DVLVRI&RPSDULVRQ
00b Every update of the cumulative value
01b Cumulative value equal to threshold value
10b Cumulative value not equal to threshold value
11b Cumulative value greater than threshold value
• The Default Threshold Values are the maximum values that
each parameter can attain.
• The Current Cumulative Values are the values computed
since the last reset of the device (either via power-cycle, BUS
DEVICE RESET, or SCSI RESET.
• The Default Cumulative Values are the values to which each
parameter is initialized at a reset condition. Default values are
zero.
• By default, Current Threshold Values = Default Threshold
Values.
Note that all types of parameter values are changeable via LOG
SELECT.
LP List Parameter. This bit should always be set to 0 to indicate
parameter codes are treated as data counters.
Parameter Length This field specifies the number of bytes of the parameter value.
Parameter Value This field indicates the actual value of this log parameter.
7DEOH±/RJ3DUDPHWHUV)LHOG'HVFULSWLRQVFRQWLQXHG