Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
5(/($6(81,7&RPPDQGKFRQWLQXHG
)LHOG 'HVFULSWLRQ
3rdPty Third Party Release allows an initiator to release a
logical unit that was previously reserved. If the
value in this field is 0, third party release is not
requested. If 3rdPty = 1, then the device server
shall release the specified logical unit, but only if
the initiator ID, 3rdPty bit, and third party device ID
are identical when compared to the RESERVE
command that established the reservation.
LongID If the Long ID bit is set to 1, the Parameter List
Length is 8 and the eight bytes of the parameter list
carry the device ID of the third party device; the
contents of the Third Party Device ID in the CDB
(byte 3) are ignored.
Third Party Device ID If the Third Party Device ID value that is connected
with the reservation release is smaller than 255, the
LongID bit may be 0 and the ID value sent in the
CDB. If LongID bit = 0, the Parameter List Length
field also = 0. If the Third Party Device ID value is
greater than 255, LongID = 1.
Device servers that support device IDs greater than
255 will accept commands with LongID = 1; device
servers that do not support IDs greater than 255
may reject commands with LongID set = 1. Device
ID formats are protocol-specific.
Parameter List Length The contents of this field specify the length, in
bytes, of the parameter list that will be transferred
from the initiator to the target.
Extent The drive supports reservations only on entire
logical units. 7KHYDOXHPXVWEH
Reservation Identification Any value in this field is ignored by the drive.
127( Assuming that the RELEASE UNIT (10) Command Descriptor Block is
valid, the drive always returns a GOOD status for this command. An
actual release only happens if the initiator has the unit reserved for itself
or a third-party initiator.
7DEOH±5(/($6(81,7&RPPDQG²)LHOG'HVFULSWLRQV