Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
5(48(676(16(&RPPDQGKFRQWLQXHG
6HQVH.H\ 'HVFULSWLRQ
0h NO SENSE. Check the Filemark/EOM/ILI bits and the Additional Sense
Code/Additional Sense Code Qualifier bytes.
1h RECOVERED ERROR. This can be caused by rounding of Mode Parameters on
a MODE SELECT, or may report that READ/WRITE error rates are reaching
subsystem specification limits for optimal operation. The device may still be able
to continue to function without any unrecovered errors for a long period of time,
however. No CHECK CONDITION is generated unless the PER bit of Mode
Page 01h is set.
2h NOT READY. The tape medium is not ready for tape operation commands.
Tape medium might not be present in the drive or may be in the process of
loading or calibrating.
3h MEDIUM ERROR. An unrecoverable WRITE, READ, or positioning error has
occurred. Detailed device-specific information may be available.
4h HARDWARE ERROR. The Additional Sense Code / Additional Sense Code
Qualifier fields may present more specific information.
5h ILLEGAL REQUEST. The Command Descriptor Block or supplied parameter
data had an unsupported or illegal operation specified. Check bytes 15, 16, and
17.
6h UNIT ATTENTION. Unit Attentions are created after a device reset, if the
medium asynchronously becomes ready to the initiator, if another initiator
changes Mode Parameters, and/or if the firmware is updated.
7h DATA PROTECTED. The current tape medium is write-protected. This can be
because the Write Protect switch on the cartridge is in its enabled position or if
the tape medium is not the appropriate type (DLTtape I or DLTtape II), or if a
software write protect is issued.
8h BLANK CHECK. An End of Data or LongGap has been encountered.
Bh COMMAND ABORTED. This key is generated when a command has been
aborted by the tape drive for some reason. Check the Additional Sense Code /
Additional Sense Code Qualifier bytes.
Dh VOLUME OVERFLOW. This key indicates that the physical end of tape medium
has been reached during writing. The initiator ignored the End of Medium
condition and continued to write to tape.
Eh MISCOMPARE. A compare error has occurred during READ by the self-tests
invoked during execution of a SEND DIAGNOSTIC command.
7DEOH±6XSSRUWHG6HQVH.H\V