Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
02'(6(16(&RPPDQG$K$KFRQWLQXHG
)LHOG1DPH 'HVFULSWLRQ
PS Parameters Savable. Not supported; must be 0.
Additional Page Length This field indicates the number of bytes in the page. Note
that this value does not include bytes 0 and 1. The length is
returned on MODE SENSE and must subsequently be set to
the same value when performing MODE SELECT.
CAP Change Active Partition. Not supported.
CAF Change Active Format. Not supported.
Active Format Not supported.
Active Partition This field indicates the current logical partition number in
use. Only partition 0 is supported.
WRITE Buffer Full Ratio Indicates how full the buffer should be before restarting
writing to the medium. The tape drive sets this to 0 (unused)
since it uses an automatic adaptive mechanism to
dynamically adjust its ratio according to the average data
rates over the SCSI bus.
READ Buffer Empty Ratio Indicates how empty the buffer should be before restarting
reading from the medium. The tape drive sets this to 0
(unused) since it uses an automatic adaptive mechanism to
dynamically adjust its ratio according to the average data
rates over the SCSI bus.
WRITE Delay Time Indicates the maximum time (in 100 ms increments) the
drive waits with a partially fully buffer before forcing the data
to tape. Note that the buffer full/empty ratio, which is
dynamic, can cause data to be written sooner than the
WRITE delay time value indicates. The WRITE delay time
defaults to 200 ms (C8h). This causes the buffer to be
flushed in 20 seconds. Minimum value is 15 (Fh); maximum
value is 6500 (1964h). This represents a range in delay from
1.5 seconds to 11 minutes.
DBR Data Buffer Recovery. Not supported, must be 0.
BIS Block Identifiers Supported. Set to 1.
RSmk Report Setmarks. Not supported, must be 0.
AVC Automatic Velocity Control. Set to 0.
SOCF Stop on Consecutive Filemarks. Set to 0.
RBO Recover Buffer Order. Set to 0.
REW Report Early Warning. Set to 0 (do not report early warning
EOM on reads).
7DEOH±'HYLFH&RQILJXUDWLRQ3DJH²)LHOG'HVFULSWLRQV