Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD 6&6,&RPPDQGV
7DQGEHUJ'/73URGXFW0DQXDO
5(48(676(16(&RPPDQGKFRQWLQXHG
)LHOG1DPH 'HVFULSWLRQ
Valid When set to 1, this field indicates that the information bytes contain
valid information as defined in the ANSI SCSI-2 specification.
Error Code A value of 70h indicates a current error – the report is associated
with the most recently received command.
A value of 71h indicates a deferred error – the report is associated
with a previous command and not as a result of the current
command.
No other values are returned in this field.
Segment Number This value of this byte is always 0.
Filemark This bit indicates that the current command has read a Filemark.
EOM End of Medium. This bit indicates that an End of Medium condition
(End of Partition or Beginning of Partition) exists. The warning is
also given by setting the Sense Key to NO SENSE and the
Additional Sense Qualifier to End of Partition or Beginning of
Partition.
ILI Incorrect Length Indicator. This bit indicates that the requested
logical block length did not match the logical block length of the data
on the tape medium. Only READ or VERIFY may cause this bit to be
set.
Sense Key In most cases, Additional Sense Code and/or Qualifier information is
available. The codes and qualifiers are covered in detail in Table 5-
89.
Information Bytes These bytes contain the differences (residue) of the requested
length minus the actual length in bytes, blocks, or Filemarks, as
determined by the command. Negative values are indicated by two’s
complement notation. The bytes are valid for all READ, WRITE,
SPACE, and VERIFY tape commands for which a CHECK
CONDITION status has been generated. The information bytes are
0 for MODE SELECT / SENSE, INQUIRY, READ BLOCK LIMITS,
and TEST UNIT READY.
FRQWLQXHG
7DEOH±5(48(676(16('DWD²)LHOG'HVFULSWLRQV