3D Innovations DLT8000 Gas Grill User Manual


  Open as PDF
of 391
 
7DQGEHUJ'DWD &RQILJXULQJ,QVWDOOLQJDQG2SHUDWLQJWKH7DSH6\VWHP
 7DQGEHUJ'/73URGXFW0DQXDO
,I« 7KHQ«
The Density Select Button is not used The illuminated indicators show data
density when the tape is being read
from and written to. The indicators
illuminate steadily; Density Override
remains extinguished.
The Density Select Button is used and the
actual recorded density is the same as the
density selected via the button
The indictor that reflects the actual data
density and the Density Override
indicators both are illuminated. For
example, if the actual data density is
set for 10.0 GB and 10.0 GB is selected
via the Select Button, the indicator next
to “10.0” illuminates.
The Density Select Button is used and the
actual recorded density differs from the density
selected via the button
1. The indicator that reflects the
actual data density illuminates
steadily.
2. The indicator reflected the
SELECTED density blinks.
3. The Density Override illuminates
steadily.
For example, if the actual tape data
density is set for 40.0 GB and the
selected density is 20.0 GB, the 40.0
indicator lights steadily, the 20.0
indicator blinks, and the Density
Override indicator illuminates steadily.
7DEOH±,QGLFDWRU/LJKW$FWLYLW\'XULQJ'HQVLW\6HOHFWLRQ
7RVHOHFWGHQVLW\YLDWKHKRVWRYHUWKH6&6,EXV
1. Use the SCSI MODE SELECT command to indicate the desired data density
(Chapter 5).
2. Write data to the tape from BOT.
 previous next