Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD $SSHQGL[&
& 7DQGEHUJ'/73URGXFW0DQXDO
If the firmware image is valid, the tape drive’s PCBA controller’s FLASH
EEPROM is updated with the new firmware image. The WRITE
PROTECTED and TAPE IN USE indicators flash again during the
controller firmware update.
& ,QWHUSUHWLQJWKH5HVXOWVRID)LUPZDUH8SGDWH
Following a firmware update procedure, two possible results can occur:
• The firmware update cartridge is unloaded. This signals a successful
update
The tape drive rewinds the cartridge, the door is unlocked, and the green
OPERATE HANDLE indicator illuminates.
• The firmware update cartridge is NOT unloaded. This signals an
unsuccessful update.
The tape drive subsystem may still be usable. Failure may be a result of:
• Power failure
• Bad firmware image on the tape
• Non-functioning FLASH EEPROMS.
Table C—2 provides troubleshooting information.
,I 7KHQ
The image is valid 1. The FLASH EEPROM containing the current
firmware is erased.
2. The new image is programmed into FLASH
EEPROM (approximately 2 minutes). Then:
• The tape drive resets
• The tape drive runs POST
• The tape drive unloads the tape
cartridge and the cartridge can be
removed. This indicates a successful
firmware update.
7DEOH&²5HVXOWVRI)LUPZDUH8SGDWH