3D Innovations DLT8000 Gas Grill User Manual


  Open as PDF
of 391
 
7DQGEHUJ'DWD &RQILJXULQJ,QVWDOOLQJDQG2SHUDWLQJWKH7DSH6\VWHP
7DQGEHUJ'/73URGXFW0DQXDO 
 6HWWLQJWKH6&6,,'
Select the appropriate SCSI ID (IDs 0 through 15 are available) for the tape system
by installing jumper blocks on the pin pairs of the connector block located on the
tape system’s PCBA (Figure 2-1). Refer to Table 2-1 for the allowable SCSI IDs.
)LJXUH±/RFDWLRQRI6&6,,'&RQQHFWRU%ORFN
SCSI ID Connector Block
Front Bezel
Pin Pair 1 / 2
A jumper must always be placed across Pin Pair 9 / 10 if
any SCSI ID other than the default (5) is selected.
 previous next