Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7DQGEHUJ'DWD &RQILJXULQJ,QVWDOOLQJDQG2SHUDWLQJWKH7DSH6\VWHP
7DQGEHUJ'/73URGXFW0DQXDO
7RVHOHFWGHQVLW\RQWKHWDSHV\VWHP
Load the tape cartridge into the tape system. The yellow Tape in Use indicator
blinks while the tape loads and calibrates.
After calibration is compete, the Tape In Use indicator remains steadily
illuminated. The appropriate tape density indicator along the left edge of the
system’s front panel illuminates to indicate the tape’s prerecorded density (if any).
Use the tape system’s density Select Button to select the desired density, if
different than that indicated by the illuminated tape density indicator. Density
selection is inactive until a WRITE from BOT is issued. The controller retains the
selected density until 1) the density selection is changed, or 2) the tape is unloaded.
An example of selection of density follows.
(;$03/(
A user loads a tape cartridge previously recorded at 20.0 GB capacity.
The user then presses the Density Select Button to select the density for
40.0 GB capacity. The following events take place:
• The yellow 20.0 indicator remains illuminated – the density has not
yet changed and the steadily illuminated indicator reflects the tape’s
recorded density.
• The yellow 40.0 indicator blinks – this signals that a density change is
pending.
• The yellow Density Override indicator illuminates.
When a WRITE from BOT occurs:
• The yellow 20.0 indicator extinguishes
• The yellow 40.0 indicator illuminates steadily
• The yellow Density Override indicator remains illuminated
Table 2-10 explains the activity of indicators during density selection.