3Com FE100 Gas Grill User Manual


  Open as PDF
of 98
 
B-4 Dell PowerEdge Cluster FE100 Installation and Troubleshooting Guide
Domain name: ____________________________
Gopher service is not enabled for IIS.
QLogic Windows NT driver version 1.19 or later.
ATI video driver is installed.
The RAID levels and LUNs are configured and initialized on the shared storage subsystem.
The NIC driver has been updated.
The recommended paging file maximum size is twice the system’s RAM capacity if the RAM capacity is 256 MB
or less, or the paging file size has been set at an amount greater than the system RAM, up to the amount of free
space on the hard-disk drive.
The recommended registry file size is 64 MB.
The NIC driver remains installed after the Service Pack installation.
'HOO3RZHU9DXOW&RQILJXUDWLRQDQG'HOO2 SHQ0DQDJH8WLOLWLHV
Dell OpenManage ATF is installed on both nodes.
Dell OpenManage Managed Node is installed on both nodes.
Dell OpenManage Data Supervisor or Data Administrator is installed on one of the nodes.
Configure the RAID level on the shared storage subsystem.
The format of the PowerVault 65
x
F logical drives is NTFS.
Drive letters for the PowerVault 65
x
F:
No. 1 __________ No. 2 _________ No. 3 __________ No. 4 __________
No. 5 __________ No. 6 __________ No. 7 __________
On Node 2, the drive letter for the PowerVault 65
x
F is the same as on Node 1.
0LFURVRIW&OXVWHU6HUYLFH,QVWDOODWLRQ
Cluster name: _____________________________
Domain name: _____________________________
Administrator’s user name: _________________________
Administrator’s password: _________________________
Name of network 1 is Public (for the LAN interconnect).
Name of network 2 is Private (for node-to-node interconnect).
Cluster IP address: _________________________
Cluster subnet mask (same as Public): ________________________
3RVW0LFURVRIW& OXVWHU6HUYLF H,QVWDOODWLR Q
Apply the cluster hotfix or reapply the Windows NT Service Pack 4.
Verify the functionality of the cluster.
Configure the Dell OpenManage Data Supervisor or Data Administrator to run in a cluster environment.
Install and set up your cluster application programs.
 previous next