3Com FE100 Gas Grill User Manual


  Open as PDF
of 98
 
Cabling the Cluster Hardware 2-3
)LJXU H  & DEO LQJD5H GX QG DQW&OXVWH UHG 6\ VWHP
,QVWDOOLQJ2SWLFDO)LEHU,QW HUIDFH&DEOHV
If you are using optical fiber interface cables in your cluster, you must install an MIA
with the optical fiber cables. Follow this procedure to connect the cluster with optical
fiber cables.
NOTE: To use optical fiber cables, your nodes must have QLogic QLA-2100F host bus
adapters with the multimode fiber SC connectors.
1. Connect an MIA to each port connector you plan to use on the PowerVault stor-
age system, and tighten the two screws on the MIA with a flat-blade screwdriver.
2. Remove the cover(s) from the optical fiber cable connector(s), and connect the
cable to the MIA.
3. Connect the other end of each optical fiber cable to the host bus adapter(s) in
each node.
copper or optical fiber
cable connected to the
host bus adapter on
each node
SP-B
SP-A
port B (one on each SP)
port A (one on
each SP)
 previous next