Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
1-8 Dell PowerEdge Cluster FE100 Installation and Troubleshooting Guide
)LJXUH([DPSOHRID3RZHU(GJH1RGH
&DEOLQJ WKH&OXVWHU+DUGZDUH
After you set up the PowerEdge Cluster FE100 hardware, you must properly cable the
system for clustering. Chapter 2, “Cabling the Cluster Hardware,” of this guide pro-
vides instructions for cabling the cluster components.
6HWWLQJ8SWKH,QWHUQDO6&6,+DUG'LVN'ULYHV
If you added new hard-disk drives to your PowerEdge system or are setting up the
internal drives in a hardware RAID configuration, you must configure the PowerEdge
Expandable RAID Controller, if applicable, and partition and format the drives before
you can install Windows NT Server, Enterprise Edition. For instructions on partitioning
and formatting SCSI hard-disk drives, refer to your PowerEdge system’s
User’s Guide
.
For instructions on setting up a RAID, refer to the
Dell PowerEdge Expandable RAID
Controller User’s Guide
.
NOTE: If you are not using a hardware-based RAID solution, you can configure a soft-
ware-based RAID after installing Windows NT. See “Using the ftdisk Driver” in
Chapter 3 for more information.
&RQILJXULQJWKH4/RJ LF+RVW%XV$GDSW HUV
See “Hard Loop ID for the QLogic Host Bus Adapters” in Chapter 3 for information
about low-level configuration of the QLogic host bus adapters.
node-to-node
interconnected NIC
LAN-connected NIC
QLogic QLA-2100 or
QLA-2100F host bus
adapters (2 required)
DRAC II (optional)