3Com FE100 Gas Grill User Manual


  Open as PDF
of 98
 
Getting Started 1-11
6H WWLQJ8SWKH6KDUHG6WR UDJH6XEV\VWHP)LEUH&KDQQHO
'LVN'ULYH V
NOTE: When formatting disks from one node, you must power down the second
node. Reboot both nodes after the configuration is modified.
You must set up the Fibre Channel disk drives in the shared storage subsystem for
clustering. The first step is to configure the RAID level for the shared storage sub-
system using the Dell OpenManage Data Supervisor or, if available, Data
Administrator. Refer to the
Dell
OpenManage Data Supervisor Installation and Opera-
tion Guide
or the
Dell
OpenManage Data Administrator Installation and Operation
Guide
for instructions on setting up a RAID in the PowerVault storage system.
After the RAID is set up, partition and format the Fibre Channel disk drives in the
shared storage subsystem, and assign drive letters to each LUN. For instructions on
partitioning and formatting the shared storage subsystem hard-disk drives, refer to
the
Microsoft Windows NT Server, Enterprise Edition Administrator’s Guide
and the
Dell
OpenManage Data Supervisor Installation and Operation Guide
or the
Dell Open-
Manage Data Administrator Installation and Operation Guide
. See “Naming and
Formatting Shared Drives” in Chapter 3 of this guide to assign drive letters for the
shared storage disk drives.
,QVWDOOLQJDQG&RQILJXULQJWKH0LFURVRIW&OXVWH U6HUYHU
6RIWZDUH
Like Windows NT Server, Enterprise Edition, you must install the Cluster Server soft-
ware on both nodes if it has not already been done. Refer to the
Microsoft Cluster
Server Administrator’s Guide
for instructions on installing and configuring the cluster-
ing software. Also refer to Chapter 3, “Configuring the Cluster Software,” in this
guide for specific information about installing and configuring Microsoft Cluster Server
on your PowerEdge Cluster FE100.
NOTE: When you set up the Microsoft Cluster Server software, Dell recommends
that you create a new domain account for the cluster administrator. Do not use the
current administrator account or any other account whose password changes
frequently.
$SSO\LQJWKH&OXVWHU+RWIL[
After you install Microsoft Cluster Server, you must apply either the cluster hotfix (if
you are running Windows NT Service Pack 3) or you must reapply the Windows NT
Service Pack 4.
If you are using Windows NT Service Pack 3, you must install the post-Service Pack 3
hotfix, clusfixi.exe. Download the clusfixi.exe hotfix from the following FTP site:
ftp://ftp.microsoft.com/bussys/winnt/winnt-public/fixes/usa/nt40/hotfixes-
postSP3/roll-up/cluster/
If you are using Windows NT Service Pack 4, simply reapply the service pack.
 previous next