3Com FE100 Gas Grill User Manual


  Open as PDF
of 98
 
Configuring the Cluster Software 3-1
&+$37(5
&RQILJXULQJWKH&OXVWHU6RIWZDUH
This chapter provides information about configuring the Dell PowerEdge Cluster FE100
system software.
Before configuring the cluster software, verify that your system hardware is properly
cabled for clustering. See Chapter 2, “Cabling the Cluster Hardware,” in this guide for
instructions on connecting the components of your PowerEdge Cluster FE100.
/RZ/HY HO6RIWZDUH&RQILJXUDWLRQ
Prior to installing the Microsoft Windows NT Server, Enterprise Edition operating sys-
tem, you must make specific low-level software configurations to the PowerEdge
Cluster FE100. Low-level software configurations are settings you make to the system
before you install the operating system.
The following subsections describe how to set the low-level software to enable
clustering.
+DUG/RRS,'IRUWKH4/RJLF+RVW%XV$GDSWHUV
The QLogic host bus adapters in one node must have the hard loop ID set to 125, and
host bus adapters in the second node must be set to 124. The default setting for the
hard loop ID on the QLogic card is 125, so you only need to change the hard loop IDs
on one node.
To change the QLogic hard loop ID to 124 on one node from the default value, use the
following procedure:
1. Start the node whose QLogic hard loop IDs you need to change.
2. Press <Alt><q> when the Press <Alt-Q> for Fast!UTIL message
appears during the boot sequence.
3. In the Fast!UTIL utility, select the first adapter and press <Enter>.
4. Select Configuration Settings and press <Enter>.
5. Select Host Adapter Settings and press <Enter>.
6. Select Hard Loop ID and press <Enter>.
 previous next