Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
3-8 Dell PowerEdge Cluster FE100 Installation and Troubleshooting Guide
When all drives have been assigned drive letters and formatted, the identical drive let-
ters for the shared drives must be assigned on the second node. To do this, enter the
Disk Administrator on the second node, right-click each drive, and assign the same
drive letter to each drive that was assigned on the first node.
NOTE: Do not use Disk Administrator to set up RAID levels on the shared storage
subsystem hard-disk drives.
8VLQJWKH IWGLVN' ULYHU
The ftdisk driver enables software-based RAID, which can be configured using the
Windows NT Disk Administrator after installing Windows NT. If you are not using hard-
ware-based fault tolerance, Dell recommends that you use Disk Administrator to
mirror (RAID level 1) the system partition.
6&6,0LQLSRUW'UL Y HUIRUWKH4/RJLF+RVW%XV$GDSWHU
The QLogic host bus adapter driver, ql2100.sys, must be version 1.19 or later. Refer to
“QLogic Host Bus Adapter Driver” found later in this chapter for instructions on how
to verify that this driver is installed.
If you need to install or upgrade the driver, use the following procedure:
1. Click the Start button, point to Settings, click Control Panel, and double-click
the SCSI Adapters icon.
2. Click the Drivers tab, and click Have Disk.
3. Insert the QLogic driver disk provided with the adapter into the diskette drive and
click OK.
Follow the instructions on the screen to complete the driver installation.
4. When the driver is installed, remove the driver diskette and restart the computer.
'UL YHUIRUWKH2SWLRQDO3RZHU(GJH([SDQGDEOH5$,'
&RQWUROO HU
The RAID controller driver, pedge.sys, must be version 2.04 or later. Refer to
“Optional RAID Controller Driver” found later in this chapter for instructions on how to
verify that this driver is installed.
NOTE: The optional RAID controller is used only for each node’s internal hard-disk
drives.