Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
4/12
Heatilator • Constitution EPA Fireplace • 480-1091H
Page 41
• Position the Fireplace
This replace may be placed on either a combustible or
noncombustible continuous at surface. Follow the in-
structions for framing in Section 6.C. Slide the replace
into position. Be sure to provide the minimum 1 in. air
clearance at the sides and at back of the replace as-
sembly. See Section 6.B.
• Refer to Figures 7.4 and 7.5.
• Locate the two protective metal hearth strips measuring
approximately 26 in. x 4 in. (660 mm x 102 mm) included
with this replace.
• Slide each metal strip 2 in. (51 mm) under front edge of
replace.
• Overlap strips in the middle of replace opening by 1 in.
(
25 mm) minimum..
• Metal strips must extend beyond the front and sides of
the replace opening by at least 2 in. (51 mm).
• Protect the front of a platform elevated above the hearth
extension with metal strips (not included with replace)
per Figure 7.5. See Section 10C for hearth extension
instructions.
Figure 7.4 Position the Protective Metal Hearth Strips
Protective metal strips are placed 2 in.(51mm) under the front of the
fireplace and must extend beyond the front and sides of fireplace
opening by 2 in. (51mm). Nail or screw metal strips in place.
Pallet
Mounting
Brackets
1 in. (25mm) Overlap
Raised Platform
Floor
2 in.
(51 mm)
1 in. (25 mm) min.
overlap
2 in.
(51 mm)
Top piece must overlap
bottom piece
Figure 7.5 Protect the Front of an Elevated Platform
B. Secure the Fireplace
C. Place Protective Metal Hearth Strips