Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
4/12
Heatilator • Constitution EPA Fireplace • 480-1091H
Page 25
3. Bafe Removal and Installation
1. Remove all ash from rebox, and extinguish all hot embers
before disposal into a metal container.
2. Remove the bafe protection channel by turning it down
and pulling it out of the rebox. See Figure 4.5
3. Remove ceramic blanket from above the bafe.
4. With a 3/16 in. Allen wrench, remove the front manifold
tube retainer bolt on the air channel under the end of the
front tube. See Figure 4.6.
Figure 4.5 Removing Bafe Protection Channel
Figure 4.6 Removing Manifold Tube
:
5. To remove manifold tube, slide the tube to one side until
one end is out of its hole. Then, while lifting that end of
the ber board bafe, pull tube up over the air channel
and out of hole at the other end. It is only necessary to
remove the rst tube in order to remove the bafe.
6. Slide ber board bafe forward to front of replace and
straight out through door. See Figure 4.7
7. To install the ber board bafe, repeat steps 2 through 4
in reverse. Be sure the ber board bafe and ceramic
blanket are pushed back fully and the blanket is down
and at.
Figure 4.7 Removing Bafe
4. Fan Replacement
Fan Cord Location
The Constitution Fireplace comes standard equipped with
two fans, installed at the factory with electric access on the
right side of replace (as you face it).