Heatiator C40 Fire Pit User Manual


  Open as PDF
of 71
 
Page 24
Heatilator • Constitution EPA Fireplace • 480-1091H
4/12
The rebox of your replace is lined with high quality rebrick,
which has exceptional insulating properties. There is no need
to use a grate; simply build a re on the rebox oor. Do not
operate the replace without bricks.
IMPORTANT: The bricks are very similar in size. Be certain
you have the proper brick in the correct location. Measure
the brick size for accuracy.
After the coals are completely cooled, remove all old
rebrick and ash from unit and vacuum out rebox.
1. Remove new brick set from box and lay out to diagram
as shown in Figures 4.3 & 4.4.
2. Lay bottom bricks in unit.
3. Install rear bricks on the top of the bottom bricks.
Slide top of bricks under clip on back of rebox wall
and push bottom of brick back.
4. Install side bricks. Slide top of brick under clips on
side of rebox and push the bottom of the brick until
it is ush with the side of the unit.
3
3
3
3
3
3
1
1
1
1
1
3
3
4 4
2
2
# Brick Size Qty. In Set
1 13-1/4” x 4-1/2” x 1-1/4” 5
2 13-1/2” x 4-1/2” x 1-1/4” w/ 1-1/2” chamfer 2
3 12” x 4-1/2” x 1-1/4” 8
4 12-1/2” x 4-1/2” x 1-1/4” 2
2. Firebrick Replacement
3
2
3
3
3
3
3
3
3
2
1
4
1
1 1
1
4
Figure 4.3 Fire Brick Congurations
Figure 4.4 Fire Brick Congurations
 previous next