Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
19
Operating The Grill
Make sure all burner controls are off. Do not attempt to light the burners if the smell
of gas is present.
For propane grills, check the connection with a soap and water solution after
attaching the hose. Make sure there is gas in the tank and it is sitting upright.
1. Make sure the drip tray is in place.
2. Light the grill burners using the instructions below.
3. Turn the control knob to HI and preheat the grill for 15 minutes. The top
cover should be closed during the preheat period.
4. Place the food on the grill and cook to the desired doneness. Adjust heat setting,
if necessary. The control knob may be set to any position between HI and LOW.
5. When using the IR main burner, be sure to allow it to be fully preheated to a
bright red glow prior to placing food products on the cooking grate.
6. With the intense temperatures that the IR burner reaches, it is highly
recommended that the grill hood be kept in the open position while it is in use.
7. When cooking on the IR main burner has been completed (SA & IA models)
and the burner is turned off, make sure no food is left on the grate above the
IR burner so no drippings will fall into the cooled burner ports.
8. To ensure quality performance of your IR Burner, be sure to run it on high
for 10 minutes after your food has been removed at the end of cooking, to
keep the burner ports clear
9. Allow the grill to cool and clean the drip tray after each use.
Lighting The Grill Burners
1. Open the hood.
2. Keep your face as far away from the burners as possible.
3. Push in and turn counter clockwise the gas control knob for the grill to the
LITE or HI position.
4. “Push igniter button; a multiple clicking noise should be heard from the
igniter indicating a spark is being provided to the burner.
5. Listen for the “Woosh” sound. If the burner does not light on the first try,
repeat immediately.
6. If the burner does not light after 5 seconds, turn the control knobs to the OFF
position. Wait 5 minutes until the gas clears before attempting to light it again.
BURNER CONTROL KNOB
IGNITER BUTTON
(continued next page)
Operation
Operation