Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
13
INSTALLATION OF YOUR DYNASTY GRILL
(continued)
Leak Testing
Perform a leak test at least once each year whether the gas supply cylinder has been
disconnected or not. In addition, anytime the gas cylinder is connected to the regulator
or any part of the gas system is disconnected or replaced, conduct the leak testing.
This applies to natural gas as well as propane gas. As a safety precaution, remember to
always leak test your grill outdoors in a well ventilated area. Never smoke or permit
sources of ignition in the area while doing a leak test. Do not use a flame, such as a
lighted match, to test for leaks. Use only a leak testing solution as specified below.
Leak Testing Procedure
1. Prepare a leak testing solution of sudsy water by mixing
in a spray bottle half liquid soap and half water.
2. Check and make sure all the control knobs are in the
OFF position.
3. Turn cylinder valve knob counter clockwise one turn
to open.
4. Apply leak-testing solution by spraying on joints of
the gas delivery system.
5. Blowing bubbles in the soap solution indicates that a
leak is present.
6. Stop a leak by tightening the loose joint or by replacing
the faulty part with a replacement part recommended by
the manufacturer. Do not attempt to repair the cylinder
valve if it should become damaged. The cylinder must
be replaced.
(continued next page)
installation
Installation