Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
11
INSTALLATION OF YOUR DYNASTY GRILL
(continued)
AIR SHUTTER
PROPER GRILL BURNER FLAME HEIGHT
(continued next page)
Adjustments and Efficiency
Prior to shipment each burner is tested and adjusted at
the factory. Due to variations in the location, conditions,
gas supply or when converting from one gas to another,
readjustment of the burners may be necessary.
The flames of the burners (except the rotisserie
burners) should be visually checked and compared to
that of the figure on the right.
Flames should be blue and stable with no yellow tips,
excessive noise or lifting. If any of these conditions exist,
check if dirt, debris, spider webs, etc. block the air
shutter or burner ports. Proceed with air
shutter adjustment.
Air Shutter Adjustment
A sheet metal disk known as an air shutter governs the
amount of air entering the burner. It is locked in place by
a setscrew, which must be loosened with a screwdriver
prior to lighting the burner.
1. To access the grill burner air shutters, set all the
knobs in the off position and remove them.
Remove the valve panel by first removing four
screws. Pull the valve panel outwards while
unplugging the cables attached to the rotary igniter.
2. With a screwdriver, loosen the lockscrew on the face
of the air shutter.
3. Light the burner. For the following instructions be
careful as the burner may be very hot.
4. Notice the flame characteristics. If the flame is
yellow, indicating insufficient air, turn the air shutter
counter clockwise to allow more air to the burner.
5. If the flame is noisy and tends to lift away from
the burner, indicating too much air, turn the air
shutter clockwise.
installation
Installation