Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
480-1081 30 4-03
North Star
EPA Certied Fireplace
10. Fan Replacement
Fan Cord Location
The North Star Fireplace comes standard
equipped with two fans, installed at the
factory with electric access on the right side
of replace (as you face it).
Fan Replacement Instructions
Power must be OFF prior to servicing!
The fan assembly may be accessed before
or after the replace has been installed.
Before Fireplace Installation:
1. Remove the 2 screws located at the
outside edge of the bottom panel as
show in Figure 30A.
2. Pull panel forward and remove from
replace.
After Fireplace Installation:
1. Remove the rebrick from the bottom of
the replace.
2. Remove the 2 screws from the access
panel in the rebox oor.
3. Pry up the access panel using the
screwdrive slot and completely remove
the panel.
Removing the Fan Assembly
1. Unplug the wire harness.
2. Lift fan off of studs and remove. Repeat for
second fan if necessary. See Figure 30B.
3. Inspect the gasket and ensure it is in good
condition.
4. Replace with new fan.
5. Reinstall bottom panel or rebox access
panel in reverse order as descibed above.
Screwdrive
r
Slot
S
c
r
e
w
s
Rem
o
v
e
2 sc
re
w
s
a
n
d
p
ull
p
a
n
e
l
fo
rw
ar
d
(B
e
fore
fire
p
la
c
e
in
s
ta
l
la
ti
o
n)
After
fireplace
installation
Unplug wire harness before
removing fan
Figure 30B-Fan Motor
Figure 30-A Accessing Fan Motor