Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
480-1081 28 4-03
North Star
EPA Certied Fireplace
6. Care and Cleaning of Glass
Your replace is equipped with ceramic super heat-
resistant glass, which can only be broken by impact or
misuse. Do not slam doors or impact the glass. When
closing doors, make sure that logs do not protrude
against the glass. Clean glass with a nonabrasive
glass cleaner, such as Windex. Abrasive cleaners
may scratch and cause glass to crack. Inspect glass
regularly. If you nd a crack or break, immediately
put the re out and return the door to your dealer for
replacement of glass before further use.
7. Care and Cleaning of Plated Surfaces
Clean 24 karat gold-plated surfaces with vinegar or a
glass cleaner before lighting your rst re.
WARNING!
When the appliance is equipped with a 24 karat gold-plated
door, you must clean all the ngerprints and oils from the
gold surface before ring the appliance for the rst time.
Use a glass cleaner or vinegar and towel to remove the
oils. If not cleaned properly before lighting your first
re, the oils can cause permanent markings on the gold
plating. After the gold plating iis cured, the oils will not
affect the nish and little maintenance is required: just
wipe clean as needed.
CAUTION:
Do not use polishes with abrasives as it will scratch
the surface.
IMPORTANT!
REMOVE ALL LABELS FROM GLASS BEFORE
LIGHTING THE FIRST FIRE IN YOUR FIREPLACE.
IMPORTANT!
Replace with 5mm ceramic glass only
8. Glass Replacement
1. Ensure that the re is out and the appliance is
cool to the touch.
2. Protect a table or counter top with padding or
towels.
3. Remove door with broken glass from the appliance
by lifting door up and off of the hinges.
4. Lay door face down on a table or counter making
sure handle and handle attachment knob hang
over the edge of the table top so door lays at,
on a soft surface.
5. Remove the screws from each glass tab (5 on
each door) using a #2 Phillips Head screwdriver.
HINT: Soak screws in penetrating oil for easy
removal.
6. Remove the glass.
7. Use only 5mm ceramic Glass, Part GLA-480.
8. Position the glass with edges evenly overlapping
the opening in the front door.
9. Replace the glass tabs. Be careful not to cross
thread the screws.
10. Tighten each tab just a few turns until each is
secured. Then continue to tighten each tab
alternately, a few turns at a time, until the glass
panel is tightened snugly, but not over tightened.
11. Replace the door on the appliance.
12. After the rst burn, recheck the tighness of the
screws.