Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Replacing the Motor Brushes
(electric motor)
Perform this procedure using Motor Brush Kit P/N 978-050.
The kit consists of two brushes, two springs, and two clips.
1. Remove both inspection covers on the motor.
2. Push in the spring clip to unhook it, then pull it out..
3. Loosen the terminal screw. Pull the brush lead away, but
leave the motor lead in place. Remove the brush and
spring.
4. Inspect the commutator for burning, excessive pitting or
gouging. A black color on the commutator is normal.
5. Install the new brush so its lead slides in the long slot of
the brush holder. Push the terminal under the terminal
screw washer. Ensure the motor lead is still connected at
the screw. Tighten the screw.
6. Place the spring on the brush as shown above. Push in
and hook the spring clip. Repeat this procedure for the
other side.
7. Reinstall both inspection covers.
Brush
Brush Holder
Ter minal Screw
Spring
Spring Clip
Commutator
Ter minal Screw
Spring Clip
Brush Lead
Inspection
Cover
NOTE: Brushes should be replaced when they are
worn to less than 1/2 inch. Check and replace
both brushes at the same time.
12 © Titan Tool Inc. All rights reserved.
If electric motor overloads and stops running,
IMMEDIATELY turn the motor off and follow the Pressure
Relief Procedure in the Cleanup section of this manual.
Wait until the motor cools (approximately 30 minutes).
Then push in the bubble top, manual reset button, turn the
motor on and pressurize the system.
For CSA approved units only: The ON/OFF switch is also
the RESET!
WARNING
English