Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Heat & Glo • Crescent II • 2083-902 Rev. G • 9/0536
Figure 12.10 Glass Assembly
E. Glass Assembly
Removing Glass
Assembly
Pull the two glass as-
sembly latches out of
the groove on the
glass frame. Remove
glass door from the
appliance (see Figure
12.10).
Replacing Glass
Assembly
Replace the glass
door on the appli-
ance. Slide the top of
glass into slot at top.
Pull out and latch the
two glass latches into
the groove on the
glass frame.
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
WARNING
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete
appliance.
F. Replacing Light Bulb
• Glass and other surfaces are hot during operation
and cool down.
• Do NOT change bulb when appliance is hot.
HOT! DO NOT TOUCH.
BURNS MAY RESULT.
WARNING
• Use cotton gloves or rag to handle bulb. (Oil film on
bulb, including skins oils, will cause premature
failure of bulb.)
• Ensure lava rock and clear rock is not under glass
when reinstalling.
• Do NOT overtighten screws.
Avoid damaging light bulb or glass.
CAUTION
• Remove logs and burner from appliance, by removing
two screws holding the pilot in place, and two screws
holding the burner in place (see Figure 12.11).
• Remove clear rock and lava rock from orange film and
around edge of ember glass.
• Remove four long sheetmetal screws holding the orange
film.
• Remove glass and orange film from bottom of appliance.
• Remove old light bulb and replace it with a new bulb (see
Figure 12.12). Recommended replacement: Sylvania
Candelabra 75 watts.
Figure 12.11 Burner Pilot and Glass Attachment
Figure 12.12 Light Bulb Location
• Reinstall the glass, orange film, burner and logs, lava
and clear rocks. For placement of logs and rock refer to
the log placement instructions in Section 12-D.
BURNER SCREWS (2)
PILOT SCREWS (2)
EMBER GLASS SCREWS (3)
LIGHTBULB
BRACKET
WITH SLOT
GLASS
ASSEMBLY