Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Heat & Glo • Crescent II • 2083-902 Rev. G • 9/0534
D. Positioning the Logs
2083-903
CAUTION: Logs are fragile.
Log Set Assembly: LOGS-Crescent II
STEP 1: Remove the rubber band from the log set and the
packing around the log. Check to see if the back lighting /
ember bed bulb works. See Replacing Light Bulb (Section
12.F) in manual if bulb needs to be replaced.
STEP 2: LOG REPLACEMENT ONLY: Remove old log set
from fireplace by removing two screws holding the pilot and
two screws holding burner in firebox. Remove old logs and
burner. Slide the new log set over the orifice and make sure
the orifice engages into the burner neck. Then install two
screws holding the pilot to the burner and two screws holding
burner to bottom of fireplace.
STEP 3: Place log (SRV2083-181) on right side of burner
between burner and firebox, and tip the log so it rests on the
burner tube.
LOGS NOT SHOWN IN PICTURE
RUBBER
BANDS
STEP 4: Place clear rock on top of orange film in front of
log set. It is recommended using the clear rock which is no
bigger than one inch.
LOCATION OF
CLEAR ROCK
BURNER
SCREWS
PILOT
SCREWS
Figure 12.1
Figure 12.2
Figure 12.3
Figure 12.5 Figure 12.6
REMOVE
PACKING