Vermont Casting RADVTCG Outdoor Fireplace User Manual


 
2626
Radiance Direct Vent Gas Heater
20012697



Rear Log
LG488
Figure 48
2. Install the rear log by plac-
ing it on the ember bed
toward the back of the
firebox. (Fig. 48) The log
should touch the back wall
of the firebox. When the
log is in place, the two (2)
notches on the bottom of
the log rest on the two (2)
ribs on the back side of the
ember bed. (Fig. 49)



Ribs for Rear Log
Ember Bed
Rib Flat Spot for
Front Left Log
Rib and Flat Spot
for Front Right Log
LG487
Figure 49



Figure 50
Front Left Log
Front Right Log
LG489
3. Install the front left and right logs
(Fig. 50) by placing them on the
ribs shown in Figure 49. Make
sure the logs line up with the flat
spots on the ember bed intended
for location purposes. (Fig. 49)
4. Install the left cross log by engag
-
ing the hole on the bottom with
the pin on the left side of the rear
log. Set front side of cross log on
notch in ember bed. (Fig. 51)
5. Install the right cross log by
engaging the hole on the bottom
with the pin on the right side of
the rear log. Set front edge of
cross log on ember bed as shown
in Figure 51.