Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
14
W415-0583 / B / 05.23.07
WARNING
Facing and/or fi nishing
material must never
overhang into the fi replace
opening.
Do not distort or force the frame
kit components.
When using a rough fi nish materi-
al (i.e.; stone), maintain a ¼” - ½”
border from the framing
components.
NON-COMBUSTIBLE
FINISHING MATERIAL
59
3
/
8
"
21
3
/
4
"
32"
4"
4"
STUD
2"
FIRESTOP
SPACER
COMBUSTIBLE
MATERIAL
2"
NON-COMBUSTIBLE
72"
24"
SPACER
STAND OFF
62
1
/
8
"
29"
44"
1"
MIN
1"
MIN
29"
22
1
/
2
"
10"
MIN
58
1
/
2
"
72"
2
9"
22
1
/
2
"
FIGURE 31
FRAMING
CLEARANCE TO COMBUSTIBLES
MAINTAIN THESE MINIMUM CLEARANCES TO COM-
BUSTIBLES:
Fireplace framing - 0” to stand-offs (top, rear & sides)
Fireplace fi nishing - 4” to sides of fi replace opening.
- 21
3
/
4
” to top of fi replace opening.
FIGURE 28
FIGURE 29
FIGURE 30
It is best to frame your fi replace after it is positioned and the
vent system is installed. Use 2x4’s and frame to local build-
ing codes.
Note: In order to avoid the possibility of exposed insulation
or vapour barrier coming in contact with the fi replace body,
it is recommended that the walls of the fi replace enclosure
be “fi nished” (ie: drywall/sheetrock), as you would fi nish any
other outside wall of a home. This will ensure that clearance
to combustibles is maintained within the cavity.
For convenience, the stand-offs have been shipped fl at. Be-
fore framing, ensure the stand-offs are opened and screwed
in place.
It is not necessary to install a hearth extension, but the fi re-
place should be raised to be fl ush with either the hearth or
the fi nished fl oor.
When roughing in the fi replace, raise the fi replace to accom-
modate for the thickness of the fi nished fl oor materials, i.e.
tile, carpeting, hard wood.
Objects placed in front of the fi replace should be kept a mini-
mum of 48” away from the front face.
IMPORTANT:
The requires a
minimum inside enclo-
sure height of 72”.
For temperature require-
ments, this area must be
left unobstructed.
It is recommended that
the enclosure be ventilat-
ed at the top and bottom
to circulate the hot air.
Non-combustible
finishing material
(ie: cement board,
brick, stone, tile)
may be used to fi n-
ish the front of the
unit.