Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
19
W415-0665 / B / 02.11.08
OPTIONAL
FRONT
GLASS
DOOR
LATCHES
RETAINER
Before the glass door can be removed, the optional front must be
removed.
The glass door is secured to the top front edge of the fi rebox with two
latches. Pull the handles of the latches forward, then lift the hooks
out from the slots in the door frame to release the top of the door.
Next, pivot forward until the top edge of the door clears the front of
the fi replace. Next gripping the sides of the door lift the door out
from the retainer along the bottom of the door.
LOG SHIPPING
BRACKET
Before installing the logs, you must fi rst
remove the log shipping brackets. Lift
up to remove.
LOG SHIPPING BRACKET
DOOR REMOVAL
FINISHING
FIGURE 37
FIGURE 38
Note: Due to the brittle material of the bricks, care must be
taken not to bend or force them into place.
Note: Refractory panels require a 24 hour curing period on a
low fl ame.
32
1
HERRINGBONE PATTERN ILLUSTRATED
5. Rest the bottom edge of the rear
panel on top of the rear portion of the
air defl ector at the back of the fi rebox
and push into place. The rear panel
is held in place when both side panels
are in position.
6. Install the left brick panel using the
same method described in step 4.
7. Replace
the burner, air
defl ector, logs
and glass door.
FIGURE 43
DECORATIVE BRICK PANEL INSTALLATION
Decorative panels may discolor after time.
1. Carefully remove the glass door and all logs. (Refer to the
“FINISHING” section)
2. Remove the two screws holding the front portion of the rear air
defl ector. Remove the pilot shield by removing the two screws as
illustrated. (Fig. 40)
3. Remove the 3 screws holding the
burner down and carefully remove the
burner. (Fig. 41)
4. Install the right brick panel by sliding the bottom edge of the panel
down the right fi rebox side then pivot the top edge of the panel into
place against the fi rebox wall. Hold in place with the brick retainers.
(Fig. 41)
STEP
#2
PILOT SHIELD
FIGURE 40
STEP
#3
FIGURE 41
FIGURE 42