Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
28
BATTERY REPLACEMENT:
1. Remove drip pan.
2. Open cart door (on cart model only).
3. Pull battery downwards (This may require use of pliers).
4. Re-install upward and push to snap - Fig. 43. (Polarity is
shown in Fig. 44).
Note:
Battery condition should be checked at least once a year.
REGULATOR AND HOSE REPLACEMENT
The pressure regulator and hose assembly supplied with the unit must be used. If replacements are needed,
contact Customer Care (888) 936-7872. Do not use the grill if the odor of gas is present. If the unit is LP, screw
the regulator into the tank and leak check the hose and regulator connections with a soap and water solution
before operating the grill. Turn all knobs to "OFF" then turn on the gas supply. If LP, is there gas in the tank?
■
Always keep your face and body as far away from the grill as possible when lighting.
■
DO NOT leave the grill unattended while cooking.
■
Keep a spray bottle of soapy water near the gas supply valve and check the connections before each use.
■
Do not attempt to "LITE" the grill if the odor of gas is present.
■
Wait 5 minutes before relighting a hot grill.
GRILL GRATES:
Method 1: Turn on “HI” for 15-20 minutes to burn any remaining food particles. After turning the grill “OFF”, use a
bristle barbeque brush to remove any remainin food particles or ash.
Method 2: The easiest way to clean the grill is immediately after cooking is completed and after turning off the
flame. Wear a barbeque mitt to protect your hand from the heat and steam. Dip a soft brass bristle barbeque
brush in a mixture of 2 cups of tap water and 1/2 cup of vinegar and scrub the hot grill. Dip the brush
frequently in the bowl of water and vinegar. Steam, created as water contacts the hot grill, assists the cleaning
process by softening any food particles. The food particles will fall onto the ceramic rods and burn or fall into
the drip pan. If the grill is allowed to cool before cleaning, cleaning will be more difficult.
Method 3: Take about 1 foot of aluminum foil, crumbled up in a ball and rubbing it over cooled grates to release
f
ood particles.
Note:
Grill grates must be re-seasoned after cleaning to prevent rust stains.
DRIP PAN AND GREASE TRAY:
T
he full width dr
ip pan with g
r
ease tray will collect grease from the grill section and boil overs and spills from
the side bur
ners
. Allo
w the pan and its c
ont
ents to cool before attempting to clean. Clean grease from the pan
often to avoid the possibility of a grease fire.
CERAMIC RODS:
It is not necessary to remove the ceramic rods for cleaning. They burn themselves clean during the next cooking
operation. Periodically the trays holding the ceramic rods need to be turned over, and shaken free of debris for a
thor
ough cleaning. How often you use the grill and the amount and type of food cooked will determine when it
is necessary to clean the trays. If grease can be seen on the top of the tubes or if you get a lot of flare-up during
cooking, the tubes need to be turned over and heated on “HI” for 30 minutes; longer for heavy soil.
CARE AND MAINTENANCE
FIG. 44
FIG. 43