Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
26
TO LIGHT THE ROTISSERIE BURNER BEFORE COOKING:
The location of the rotisserie burner makes it more susceptible to strong wind conditions, more so than the
protected grill burners. For this reason you should avoid operating the rotisserie during windy conditions. As an
added safety feature we’ve equipped the burner with an automatic safety valve which will not allow gas to flow
to the rotisserie burner unless the following conditions are present with the knob on:
1. The safety valve button is pressed, and held down.
2. The safety valve thermocouple has been sufficiently heated to keep safety valve open.
Open the lid. Push and hold the ignition button. You’ll hear a snapping sound. Turn the control knob to “HI”.
Engage the safety valve button and continue to hold until the burner is lit. Once lit, turn control knob to desired
setting. If the burner does not light within 4 to 5 seconds, release the safety valve button and turn the control
knob to “OFF” and wait 5 minutes before trying again.
■
I
f relighting a hot burner, wait 5 minutes.
■
Never leave the control knob on if rotisserie is not in use.
■
Never light a grill burner under the rotisserie while rotisserie burner is lit.
MANUAL LIGHTING:
To manually light the rotisserie, place a butane lighter
near the tip of the thermocouple as shown in Fig. 38. Turn
the c
ontrol knob to “HI”. Hold the safety valve button in
for about 4 to 5 seconds or until the burner remains lit.
Once lit, turn control knob to desired setting. If the
burner does not light within 4 or 5 seconds, release the
safety valve button and turn the control knob to “OFF” and
wait 5 minutes before trying again.
WARNING!
Keep hands and face away from front of burner! STAND TO
THE SIDE
WHEN LIGHTING. ONCE LIT MOVE HAND AWAY
QUICKLY.
WARNING!
Electrical Grounding Instructions: This appliance (rotisserie motor) is equipped with a three-prong (grounding) plug
for your protection against shock hazard and should be plugged directly into a properly grounded three-prong
r
eceptacle or a three-prong grounded extension cord rated for outdoor use. Do not cut or remove the grounding
prong from this plug. Use only a ground fault interrupter (GFI) protected circuit.
The rotisserie motor must be electrically grounded in accordance with local codes or, in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70-1990. Keep the rotisserie motor electric cord away from
the heated surfaces of the grill. When not in use, remove and store the motor in a dry location. To protect
against electric shock, do not immerse the cord or plug in water or other liquid. Unplug rotisserie unit from the
outlet when not in use and before cleaning. Allow the rotisserie to cool before putting on or taking off parts.
Thermocouple
USING THE ROTISSERIE
FIG. 38