DCS "BGB" Series Gas Grill User Manual


 
23
The smoker system on each grill consists of a stainless steel slide out tray
which is positioned above a 3,500 Btu/hr burner. The burner is controlled by
a precision brass valve which is capable of being turned down to very low
heat levels. The system may be used alone for low temperature roasting and
s
moking or in conjunction with any combination of other burners. When
using the smoker system in conjunction with the optional infrared rotisserie
burner, you’ll find it helpful to use the low setting of the smoker burner to
minimize the heat rising up to the rotisserie basting pan. Staggering the
meat away from the smoker burner also helps.
To minimize burn potential do not completely remove the smoker tray when
hot.
TO LIGHT THE SMOKER BURNER:
Open the lid and r
emove the smoker tray. Locate the burner visually by
looking through the cut-out in the valve panel. Push and hold the ignition
button, turn the control knob to the “HI” position until the burner is lit or 4
seconds pass. If the burner doesn’t ignite, wait 5 minutes for any
accumulated gas to dissipate, then try again. If the burner will not light
after several attempts, wait 5 minutes, then match light using a paper book
match through the cut-out in the valve panel. Once lit, fill the smoker tray
and replace.
WOOD CHIPS:
There are many wood chips available for purchase and selection is based on
personal taste. The most common wood chips used are mesquite or hickory.
Mesquite has a sweeter taste and is commonly used with poultry and seafood. Hickory is best suited for red
meats. Use of oak, cherry, maple, aspen or apple is also common while aromatic herbs like sage, bay leaves,
thyme or basil may also be used. Soaking the chips in water before using them will help ensure the wood chips
smoke and do not flame up. To start, you may want to use the “HI” position to start the chips smoking, then
reduce the heat to a lower level to prevent them from drying out and flaming. If the wood chips do flame up,
add a small amount of water to extinguish the flame. This should be done carefully through the top in the grill
area, or by pulling the tray out slightly. Use caution when adding water to a hot tray to avoid steam burns, and
nev
er c
ompletely remove a hot tray. When smoking, the lid should remain closed as much as possible to
maximize the effect. During extended roasting periods it is normal to add fresh wood chips to the tray several
times.
USING THE SMOKER SYSTEM
FIG. 31 36 / 48 Grill Smoker System
FIG. 32