Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Barbecue Owner’s Manual
www.calspas.com
cleaned with hot soapy water, rinsed, dried and buffed with a heavy pile cloth.. Be sure to rinse
thoroughly and to wipe dry to avoid watermarks.
Note: DO NOT use oven cleaners or abrasive cleaners on enameled surfaces. They may damage the fin-
ish, causing accelerated wear.
30” Food Warmer
• Be careful cleaning any part of this appliance, particularly the drawer box and back of the drawer
face. All parts of the drawer can be cleaned with hot soapy water, rinsed, dried and buffed with a
heavy pile cloth. Always try this first, as it is the mildest cleaning procedure.
• Be sure the warming drawer is turned off and the appliance is cooled before using any type of aerosol
cleaner on or around the appliance. The chemical that produces the spraying action could, in the pres-
ence of heat, ignite or cause metal parts to corrode.
• Use the mildest cleaning procedure first. Some brands of cleaners are harsher than others, read their
directions. Try in a small area first.
•To avoid marring the surface always rub the metal finishes in the direction of the polish grain lines.
The cleaner will be more effective when used in the direction of the polished lines.
• Use only clean sponges, soft cloths, paper towels, plastic or non-metal soap pads for cleaning or
scouring, as recommended in this section.
• Be sure to rinse thoroughly and to wipe dry to avoid watermarks.
Drawer Clean the drawer with warm soapy water.
Drawer Front Clean same as drawer.
Gasket Clean with warm soapy water.
Knobs The ON/OFF temperature knob may be removed for cleaning.
Drawer Cavity Same as drawer above.
Heating Element Care should be taken when cleaning the heating element. Only clean the element
when the unit is cool. Use warm soapy water on damp cloth.
LED Light Replacement
1. Place the lens removal key in the LED housing. Make sure the pins of the removal key are placed
inside the lens.
2. Turn the removal key and pull the lens from the housing.
3. Pull out the LED light lamp from the socket.
4. Insert the new LED light into the socket. Make sure both connector pins are seated firmly in the
socket.
5. Turn on and off the lights to test its performance before the LED light lens is replaced.
Granite Top
Stone is a natural product and simple care and maintenance will keep it looking beautiful. Here are some
recommendations for routine care and cleaning:
Page 49
Cleaning and Maintenance
12/17/04