Cal Flame G3000 Charcoal Grill User Manual


  Open as PDF
of 64
 
Barbecue Owner’s Manual
Operating the Cal Flame Entertainment Center
www.calspas.com
Remote Control Operation
TV Power
Press this button to turn on the set.
Press the button again to turn the set off.
Direct Access (0-9, 1--) Number Buttons
Use these buttons to select a channel. The channel
number chosen will be displayed on the screen for
about four seconds. To select channels 0-99, press
two numbers. For example, to select channel 8, press
0,8. To select above 100, press the 1-button, then the
number buttons for the last two digits of the channel.
For example, to select channel 115, press 1--, 1,5.
CHANNEL Up and Down
Use these buttons to select pre-programmed channels
of two select channels up or down.
VOLUME Up and Down
Use these buttons to raise or lower the volume level
of the Wired Headphones or External Speakers if
installed. They are also used to make adjustments in
the picture mode.
Figure 49. Remote control
NOTE: These buttons will not affect the volume of wireless headphones or a wired RF modulator.
When using these devices, the volume must be adjusted with the headphone volume control or
with your radios volume control.
MENU Button
Press the MENU button. The MENU display appears. Use the Channel Up and Down buttons to select
the desired function, then press ENTER button to end the choice.
TV/VIDEO Button
Press this button to access the AUDIO/VIDEO input jacks, on the front and rear of the TV. As the but-
ton is pressed, the on-screen display will cycle as follows:
MUTE Button
Press this button to turn the TV sound off. Press again to restore sound to the previously set level.
MUTE may also be released by pressing the VOLUME +/-.
TV AV1
AV2
AUX
Power
Channel Pad
PRC/Sel
Mute
Display
Vol +
Eject/ DVD
TV/DVD
Auto Program
Skip/Search
Erase/Add
Channel Up
Channel Down
Enter
Menu
Return
Vol -
TV
DVD
VCR
Audio
Play
FF
REW
NEXT
PREV
SubTitle
Pause/Replay
Stop
Program
Angle
TV/CATV
Page 42
12/17/04
 previous next