Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Barbecue Owner’s Manual
www.calspas.com
6. Stop a leak by tightening the loose joint or by replacing the faulty part with a replacement part recom-
mended by the manufacturer. Do not attempt to repair the cylinder valve if it is damaged. The cylin-
der must be replaced.
7. If you are unable to stop a leak, shut off the gas supply at the cylinder valve and remove the cylinder
from the grill. Call an authorized gas appliance service technician or an LP gas dealer. Do not use the
appliance until the leak is corrected.
8. Push in and turn any control knob to release pressure in the hose and manifold.
9. Turn off the control knob.
Natural Gas Requirements
Always check the rating plate to make sure the gas supply you are hooking up to is the gas type the grill
is manufactured for.
IMPORTANT: All Cal Flame grills are manufactured with the highest regard to safety. For this
reason, Cal Flame™ grills are either manufactured to operate on either liquid
propane (LP) or natural gas (NG) and cannot be converted. To verify the grill’s
operating fuel, remove the bottom drip pan and check the serial number label on
the left. Either LP or NG will be marked on the operating tab, indicating the proper
operating fuel. Attempting to convert Cal Flame™ grills from one fuel to another
may result in serious injury and void the warranty coverage.
IMPORTANT: Never connect the grill to an unregulated gas supply.
The installation of this appliance must conform with local codes or, in the absence of local codes, to the
national fuel gas code, ANSI Z223.1a-1998. Installation in Canada must be in accordance with the stan-
dard CAN/CGA-B149.2, Propane Installation Code.
Natural gas connections must be performed by a licensed contractor or local gas company representative.
Ensure that the service supplying the grill is fitted with a shut off valve conveniently positioned near the
grill and giving ease of access.
Your Cal Flame™ grill for use with natural gas comes equipped with its own regulator which MUST
NOT be removed. If, this regulator needs to be replaced use only the type specified by Cal Flame™ for
this appliance.
1. Remove the rear panel from the barbecue to gain access to the regulator and gas connection point.
2. Connect a suitable flex connector to the grill regulator.
Page 9
Delivery and Set-Up
12/17/04