Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
54 Removing and Replacing Parts
www.dell.com | support.dell.com
To replace a connector cover, orient the cover notch-side-up and snap it into
the connector cutout.
RJ-11/RJ-45 Board
Removing the RJ-11/RJ-45 Board
1 Follow the instructions in “Preparing to Work Inside the Computer.”
2 Remove the system board.
3 Remove the 4-mm screw from the RJ-11/RJ-45 board.
NOTICE: The plastic tab is fragile; pull it back only far enough to remove the
board assembly.
4
Reach into the enclosure and, while pulling the tall plastic tab away
from the board assembly to release it, lift out the assembly.
When replacing the RJ-11/RJ-45 board assembly, protect the wiring harness
by routing it between the plastic posts.
4-mm screw
64mcwc11.book Page 54 Tuesday, April 3, 2001 9:58 AM