Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
56 | MODEL FSSBID 100H: CONNECTING DEVICES INSIDE YOUR SMART MOBILE
STAND’S CABINET
99-00962-20 REV C0
3. Connect the DB9 end of the SMART DB9 to USB adapter cable (included with
your SMART Board
for Flat-Panel Displays interactive overlay) to your pen tray.
NOTE
You already connected the other end of this cable to your
SMART Hub SE240 (page 43).
TIP
– Route this adapter cable through your SMART Mobile Stand’s connection
panel and up the prewired cable harness, leaving some slack throughout
the length of it.
– Loosen the hook-and-loop fastener strap securing cables below the
connection panel, coil the DB9 to USB adapter cable’s excess length, and
then secure it together with the rest of the cables with the hook-and-loop
fastener strap.
4. Connect your interactive overlay’s power cable (included with your interactive
overlay) to the right side of its power supply.
5. Route the power cable through the connection panel from right to left, behind
the hydraulic pump and down the cabinet’s rear support tube, and then connect
the other end to an available receptacle on your SMART Mobile Stand’s
power bar.
TIP
Coil and bundle the excess cable with the included hook-and-loop
fastener strap.
NOTES
• Don’t connect your SMART Mobile Stand to a power outlet before you install
the rear access panels (page 58).
• If you move your SMART Mobile Stand with a SMART Board
for Flat-Panel
Displays
interactive overlay installed, secure the pens in the pen tray so that
they don’t fall out.