3Com FSSBID 100 Gas Grill User Manual


 
99-00962-20 REV C0
53 | MODEL FSSBID 100H: CONNECTING DEVICES INSIDE YOUR SMART MOBILE
STAND’S CABINET
9. Route the other end of the camera cables back through the connection panel
from right to left, and then connect them to your SMART Board interactive display
frame’s controller box, coiling the excess cable and fastening it to the speaker
panel with cable ties, as shown on page 53.
TIP
Leave some slack throughout the length of these cables. Don’t pull them tight.
Cable Connections to Your SMART Board interactive display frame
Connect the USB cable included
with your interactive display
frame to the controller box, coil
the excess cable, and then fasten
it to the clip on the speaker panel
with a plastic cable tie.
Coil and fasten the excess
camera cables to the clips
on the speaker panel
with plastic cable ties.
Power Cable to
Your Controller Box
with Strain Relief Loop
Speaker Panel
Camera
Camera
Route camera cables up
your SMART Mobile Stand’s
prewired cable harness,
down behind the speaker
panel and along the inside
edge of the pencil ledge.